Oh okay, thanks again.
I think that work somehow fine, but as I think fan0 is set by default as the p.c. fan, so that should work, but via the LCD display only the redundant p.c. fan will start spinning if I turn the fan up under temperature, is that normal?
And will fan0 spin while printing as well as p.c. fan.
But my problem now is that when I turn x or z axis always the same motors start turning, the x axis motor and the right z motor from my to z axis.
So how can I change the software for my builded axis configuration, which you can see in my first message on this topic.
Good night.
Paul Anton Schenker
I think that work somehow fine, but as I think fan0 is set by default as the p.c. fan, so that should work, but via the LCD display only the redundant p.c. fan will start spinning if I turn the fan up under temperature, is that normal?
And will fan0 spin while printing as well as p.c. fan.
But my problem now is that when I turn x or z axis always the same motors start turning, the x axis motor and the right z motor from my to z axis.
So how can I change the software for my builded axis configuration, which you can see in my first message on this topic.
Good night.
Paul Anton Schenker