I am running KimbraMarlin Dev and am experiencing a .06mm slope from the front of a skirt around a 30mm x30mm test cube to the back.
My X-min and Y-min are the front left corner of the hotbed. I see ABL actively moving the Z axis while printing. If I put a feeler gauge under the probe in the front right corner while running a G29 V4 the output shows the front right corner being different. I probe 16 points on the bed after homing X, Y and Z in the front right corner.
Does it make a difference WHERE Z is homed before the G29?
My printer is a modified Prusa i3 using Openbuilds V-Slot extrusions, 8mm Acme rods for the Z axis with anti-backlash nuts, Ramps 1.4 and a .5" Mic6 hotbed.
My X-min and Y-min are the front left corner of the hotbed. I see ABL actively moving the Z axis while printing. If I put a feeler gauge under the probe in the front right corner while running a G29 V4 the output shows the front right corner being different. I probe 16 points on the bed after homing X, Y and Z in the front right corner.
Does it make a difference WHERE Z is homed before the G29?
My printer is a modified Prusa i3 using Openbuilds V-Slot extrusions, 8mm Acme rods for the Z axis with anti-backlash nuts, Ramps 1.4 and a .5" Mic6 hotbed.