Quantcast
Channel: Reprap Forum - Firmware - Marlin
Viewing all articles
Browse latest Browse all 12089

Re: Marlin RC8 AUTO BED LEVELING BILINEAR

$
0
0
Quote
gavatron3000
Hey mate I've had similar issues with this as well, I've found it hard to setup and the gcodes don't seem to respond correctly either, I abandoned the auto bilinear leveling and just stuck with manual mesh leveling and that works perfectly. It stores correctly and you only have to do it once, and use M420 S1 in your starting gcode to activate it each time. Plus it's very easy to adjust individual points to get a perfect mesh

Hi gavatron,
How exactly do you adjust the individual points after you've gone through the whole leveling procedure? I've been doing it with a G29 S3 xn yn zn command, which is a bit of a pain. Is there a way to edit one individual point through the lcd screen without having to do the whole thing over again?

Viewing all articles
Browse latest Browse all 12089

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>