It depends which system you are talking about.
M500 used to save the mesh in the UBL system, but that was problematic for a number of reasons.
M500 no longer saves the mesh in UBL. It is my belief it will save the mesh when using Bi-Linear leveling in RC-8. You can verify that pretty quickly.
M500 used to save the mesh in the UBL system, but that was problematic for a number of reasons.
M500 no longer saves the mesh in UBL. It is my belief it will save the mesh when using Bi-Linear leveling in RC-8. You can verify that pretty quickly.