Hey guys,
I made the move from rc6 to rc8 and have configured to use the bilinear bed leveling.
By issuing a G29 my machine begins probing and goes through its probing routine. I see the resulting mesh in the terminal, all good.
Now if I issue G29 S1 to save the mesh it just probes again but doesn't seem to echo a save command, it just echos G29. likewise when I issue G29 A to activate the mesh it just says G29 in the terminal and begins probing again.
I can't seem to get the mesh to apply for a print or save and I believe I may have missed a step or I'm issuing contradicting gcodes. I have a feeling if I issue a G28 after a G29 it will wipe the mesh, but again documentation on this new feature is elusive and minimal.
Could someone point me in the right direction?
Cheers
Gav
I made the move from rc6 to rc8 and have configured to use the bilinear bed leveling.
By issuing a G29 my machine begins probing and goes through its probing routine. I see the resulting mesh in the terminal, all good.
Now if I issue G29 S1 to save the mesh it just probes again but doesn't seem to echo a save command, it just echos G29. likewise when I issue G29 A to activate the mesh it just says G29 in the terminal and begins probing again.
I can't seem to get the mesh to apply for a print or save and I believe I may have missed a step or I'm issuing contradicting gcodes. I have a feeling if I issue a G28 after a G29 it will wipe the mesh, but again documentation on this new feature is elusive and minimal.
Could someone point me in the right direction?
Cheers
Gav