Hi,
just a quick question 'cause I am not sure about this feature.
Is it possible to save the mesh data to eeprom - like in the UBL version of Marlin?
Marlin wiki says it throws the data away - but there is no reference to the RC. So does it on RC8 or does it not?
Form "Mesh Bed Leveling" on the Github page
***********
The probed points will also be saved in the EEPROM if it has been enables. Otherwise a new probe sequence needs to be made next time the printer has been turned on.
***********
So it does store the mesh data for the manual probing but not for auto?
Sorry guys I am completely lost on this storage or not.
If someone can point me to a site to read more about the current state of RC and wiki entries I am happy to read them
just a quick question 'cause I am not sure about this feature.
Is it possible to save the mesh data to eeprom - like in the UBL version of Marlin?
Marlin wiki says it throws the data away - but there is no reference to the RC. So does it on RC8 or does it not?
Form "Mesh Bed Leveling" on the Github page
***********
The probed points will also be saved in the EEPROM if it has been enables. Otherwise a new probe sequence needs to be made next time the printer has been turned on.
***********
So it does store the mesh data for the manual probing but not for auto?
Sorry guys I am completely lost on this storage or not.
If someone can point me to a site to read more about the current state of RC and wiki entries I am happy to read them